Site Of Operation; Installing The Water Trap - Dräger Infinity Delta Instructions For Use Manual

Infinity delta series patient monitoring device

Hide thumbs Also See for Infinity Delta:

Table of Contents

Site of Operation

The site of operation must meet the temperature, humidity, and atmospheric pressure

requirements listed in appendix C. In addition, observe the following guidelines:

Make sure that the platform which supports the module is large enough, level,

Make sure that the fan exhaust screen at the rear of the module and the

ventilation holes on the underside are not obstructed.

Place the module at least 25 cm (10 inches) from any possible source of

ignition, such as sparking.

Place the module close enough to the patient so that the sampling tubing can

reach the airway T-connector and the exhaust tubing the hospital's exhaust

gas scavenging system without stretching.

Install the water trap into its receptacle on the Scio module by pushing against the

Scio. A click indicates that it is seated properly. Confirm that the water trap is empty

(for information on replacing the water trap, see page 23-25).

Show Quick Links

Table of Contents

Infinity delta xl Infinity kappa