Dräger Infinity Delta Instructions For Use Manual page 496

28 P
ERIPHERAL
Menu
Description
Selection
Click on one of the following settings to configure the indicated functions:
Pressure When ON, the first set of adjacent
Overlap invasive pressure waveforms (up to
four, counting from the top) are
overlapped in single channel. The
bottom line is a common zero point.
The top line is the upper limit of
whatever scale was configured for
each overlapped waveform.
Parameter names and their assigned
scales are listed across the top of the
overlap channel.
1 Sec. Time Displays vertical markers at 1-s
Lines intervals in waveform channels
Pressure Determines setting for the pressure
Grids grids displayed in the invasive
pressure channels.
Video Determines quality of the video
Resolution display
Sweep Speed Determines waveform sweep speed
Parameter Moves parameter boxes to right or
Display left of the waveform display
The Elapsed Time Key
Elapsed Time Displays or removes up to two timers
in bottom left corner of ISD screen
NOTE: Click on timer to reset after
displayed.
The Surgical Display - Save/Restore Submenu
This submenu allows you to configure the following functions.
Restore Setup Restores setup highlighted in
second menu column
Save Setup Saves setup highlighted in second
menu column
Rename Accesses data entry screen
Setups
Last Saved/ Displays most recently saved or
Restored restored ISD setup
New Setup Displays current ISD setup
28-22
D A
EVICES AND
The Surgical Display - Display Options Submenu
D /D
ELTA
S
SSOCIATED OFTWARE
Settings
• ON
• OFF
• ON
• OFF
• None
• 25%
• 50%
• High
• Medium
• Low
• Slow
• Normal
• Fast
• RIGHT
• LEFT
Click on one of the following settings:
• Begin Timer A
• Begin Timer B
• Remove Timer A
• Remove Timer B
Click on the setting of your choice.
Click on the setting of your choice.
Name and rename ISD setups using the
procedures described in chapter 2,
Monitor Setup (page 2-5).
Not applicable
Not applicable
XL/K
ELTA APPA
VF8