Simple Network Time Protocol (Sntp) Commands; Sntp Broadcast Client Poll-Interval; Sntp Client Mode - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

4.4 Simple Network Time Protocol (SNTP) Commands

This section describes the commands you use to automatically configure the system time
and date by using SNTP.

4.4.1 sntp broadcast client poll-interval

This command sets the poll interval for SNTP broadcast clients in seconds as a power of
two where <poll-interval> can be a value from 6 to 16.
Default
Format
Mode
4.4.1.1 no sntp broadcast client poll-interval
This command resets the poll interval for SNTP broadcast client back to the default value.
Format
Mode

4.4.2 sntp client mode

This command enables Simple Network Time Protocol (SNTP) client mode and may set
the mode to either broadcast or unicast.
Default
Format
Mode
4.4.2.1 sntp client mode
This command disables Simple Network Time Protocol (SNTP) client mode.
Format
Mode
4-10
6
sntp broadcast client poll-interval <poll-inter-
val>
Global Config
no sntp broadcast client poll-interval
Global Config
disabled
sntp client mode [broadcast | unicast]
Global Config
no sntp client mode
Global Config
v1.0, December 2005
Port and System Setup Commands