Subaru 2002 IMPREZA Service Manual page 2010

DIFFERENTIALS
12) Insert the DOJ into rear differential.
(1) Install the ST to rear differential.
ST 28099PA090 SIDE OIL SEAL PROTEC-
TOR
(2) Install the spline shaft until the spline portion
is inside the side oil seal using ST.
ST 28099PA090 SIDE OIL SEAL PROTEC-
TOR
(3) Remove the ST.
ST 28099PA090 SIDE OIL SEAL PROTEC-
TOR
13) Hereafter, reassemble in the reverse order of
disassembly.
2. VA-TYPE
1) Disconnect the ground cable from battery.
2) Move the select lever or gear shift lever to "N".
3) Release the parking brake.
4) Loosen both wheel nuts.
5) Jack-up the vehicle and support it with rigid
racks.
6) Remove the wheels.
7) Remove the rear exhaust pipe and muffler.
Non-turbo model without OBD
<Ref. to EX(w/oOBD)-13, REMOVAL, Rear Ex-
haust Pipe.> and <Ref. to EX(w/oOBD)-14, RE-
MOVAL, Muffler.>
Non-turbo model with OBD
<Ref. to EX-11, REMOVAL, Rear Exhaust Pipe.>
and <Ref. to EX-12, REMOVAL, Muffler.>
REAR DIFFERENTIAL SIDE OIL SEAL
DR0007
G3M1026
DI-60
8) Remove the DOJ of rear drive shaft from rear dif-
ferential.
(1) Remove the ABS sensor cable clamp and
parking brake cable clamp from bracket.
(A) ABS sensor cable clamp
(B) Parking brake cable guide
(2) Remove the ABS sensor cable clamp from
trailing link.
(3) Remove the ABS sensor cable clamp and
parking brake cable guide from trailing link.
(A) Parking brake cable guide
(B) ABS sensor cable clamp
H3M1397B
H3M1398
H3M1399B