Subaru 2002 IMPREZA Service Manual page 1606

AUTOMATIC TRANSMISSION (DIAGNOSTICS)
6. Subaru Select Monitor
A: OPERATION
1. READ DIAGNOSTIC TROUBLE CODE
1) Prepare the Subaru Select Monitor kit.
2) Connect the diagnosis cable to Subaru Select
Monitor.
3) Insert the cartridge into Subaru Select Monitor.
<Ref. to AT-6, PREPARATION TOOL, General De-
scription.>
4) Connect the Subaru Select Monitor to data link
connector.
(1) Data link connector located in the lower por-
tion of instrument panel (on driver's side).
(2) Connect the diagnosis cable to data link
connector.
NOTE:
Do not connect scan tools except for Subaru Select
Monitor and OBD-II general scan tool.
SUBARU SELECT MONITOR
5) Turn the ignition switch to ON (engine OFF) and
Subaru Select Monitor switch to ON.
6) On the «Main Menu» display screen, select the
S2M0285
{Each System Check} and press [YES] key.
7) On the «System Selection Menu» display
screen, select the {Transmission Control System}
and press [YES] key.
8) Press the [YES] key after displayed information
of transmission type.
9) On the «Transmission Diagnosis» display
screen, select the {Diagnostic Code(s) Display}
and press [YES] key.
10) On the «Diagnostic Code(s) Display» display
screen, select the {Latest Diagnostic Code(s)} or
{Memorized Diagnostic Code(s)} and press [YES]
key.
NOTE:
• For detailed operation procedure, refer to the
SUBARU SELECT MONITOR OPERATION MAN-
S2M0286
UAL.
• For detailed concerning the diagnostic trouble
codes (DTC), refer to the DIAGNOSTIC TROUBLE
CODE LIST. <Ref. to AT-27, List of Diagnostic
Trouble Code (DTC).>
2. READ CURRENT DATA
1) On the «Main Menu» display screen, select the
{Each System Check} and press [YES] key.
2) On the «System Selection Menu» display
screen, select the {Transmission Control System}
and press [YES] key.
3) Press the [YES] key after displayed information
of transmission type.
4) On the «Transmission Diagnosis» display
EN0768
screen, select the {Current Data Display & Save}
and press [YES] key.
5) On the «Data Display Menu» display screen, se-
lect the {Data Display} and press [YES] key.
6) Using the scroll key, move the display screen up
or down until desired data is shown.
• A list of the support data is shown in the following
table.
AT-20
(A) Power switch
S2M0288C