Subaru 2002 IMPREZA Service Manual page 2060

DRIVE SHAFT SYSTEM
5) Using the ST1 and ST2, remove the bearing by
pressing inner race.
ST1 927430000 HOUSING STAND
ST2 927440000 BEARING REMOVER
CAUTION:
• Do not remove the bearing unless damaged.
• Do not re-use the bearing after removal.
6) Remove the tone wheel bolts, and then remove
the tone wheel from hub (only vehicle equipped
with ABS).
7) Using the ST, press the hub bolt out.
ST 927080000 HUB STAND
CAUTION:
Be careful not to hammer the hub bolts. This
may deform the hub.
REAR AXLE
D: ASSEMBLY
CAUTION:
When the hub is to be removed from housing,
replace the bearing set and oil seal with new
ones.
1) Using the ST, press the new hub bolt into place.
CAUTION:
• Ensure the hub bolt closely contacts hub.
• Use a 12 mm (0.47 in) hole in the ST to pre-
vent the hub bolt from tilting during installation.
ST 927080000
G4M0252
2) Remove foreign particles (dust, rust, etc.) from
mating surfaces of the hub tone wheel, and then in-
stall the tone wheel to hub (only vehicle equipped
with ABS).
CAUTION:
• Ensure the tone wheel closely contacts hub.
• Be careful not to damage the tone wheel
teeth.
G4M0228
DS-30
HUB STAND
(1) Tone wheel
G4M0230
S4M0370A