DIAGNOSTIC PROCEDURE FOR NO-DIAGNOSTIC TROUBLE CODE (DTC)
AUTOMATIC TRANSMISSION (DIAGNOSTICS)
Step
10
CHECK INPUT SIGNAL FOR TCM.
Measure the signal voltage for TCM while turn-
ing power switch to ON.
Connector & terminal
(B55) No. 23 (+) — Chassis ground (–):
11
CHECK POOR CONTACT.
Check
Is the voltage less than 1 V?
Is there poor contact?
AT-118
Yes
Go to step 11.
Replace the TCM.
<Ref. to AT-46,
Transmission Con-
trol Module
(TCM).>
Repair the poor
A temporary poor
contact.
contact of the con-
nector or harness
or connector in
power switch cir-
cuit.
No