Subaru 2002 IMPREZA Service Manual page 2088

ABS
4. Front ABS Sensor
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Disconnect the front ABS sensor connector lo-
cated next to the front strut mounting house in en-
gine compartment.
3) Remove the bolts which secure sensor harness
to strut.
4) Remove the bolts which secure sensor harness
to body.
(1) To front ABS sensor connector
(2) Bracket
5) Remove the bolts which secure front ABS sen-
sor to housing, and remove the front ABS sensor.
CAUTION:
• Be careful not to damage the pole piece locat-
ed at tip of the sensor and teeth faces during re-
moval.
• Do not pull the sensor harness during remov-
al.
FRONT ABS SENSOR
B: INSTALLATION
1) Temporarily install the front ABS sensor on
housing.
CAUTION:
Be careful not to strike the ABS sensor's pole
piece and tone wheel's teeth against adjacent
metal parts during installation.
B4M1442
2) Install the front ABS sensor on strut and wheel
apron bracket.
Tightening torque:
32 N·m (3.3 kgf-m, 24 ft-lb)
B4M1728C
B4M2209
ABS-14
(1) To front ABS sensor connector
(2) Bracket
B4M2209
B4M1728C