Subaru 2002 IMPREZA Service Manual page 1566

AUTOMATIC TRANSMISSION
13) Remove the inhibitor switch from transmission.
(A) Inhibitor switch
14) Disconnect the inhibitor switch harness con-
nector from inhibitor switch.
D: INSTALLATION
1) Connect the inhibitor switch harness connector
to inhibitor switch.
2) Install the inhibitor switch to transmission case.
(A) Inhibitor switch
3) Move the range select lever to neutral position.
4) Using the ST, tighten the bolts of inhibitor switch.
ST 499267300 STOPPER PIN
Tightening torque:
3.5 N·m (0.36 kgf-m, 2.6 ft-lb)
(A) Inhibitor switch
(B) Range select lever
5) Install the select cable to range select lever.
INHIBITOR SWITCH
6) Install the plate assembly to transmission.
Tightening torque:
T: 25 N·m (2.5 kgf-m, 18.1 ft-lb)
B3M1033B
7) Install the washer and snap pin to range select
lever.
B3M1033B
8) Install the front and center exhaust pipes. (Non-
turbo model)
Except 3.0 L model
<Ref. to EX(w/oOBD)-10, INSTALLATION, Front
Exhaust Pipe.> or <Ref. to EX-8, INSTALLATION,
Front Exhaust Pipe.>
9) Install the center exhaust pipe. (Turbo model)
<Ref. to EX(TURBO)-9, INSTALLATION, Center
Exhaust Pipe.>
10) Lower the vehicle.
11) Install the inhibitor switch connector from stay.
B3M1034B
AT-30
(A) Select cable
(B) Plate ASSY
(A) Snap ring
(B) Select cable
(C) Range select lever
(D) Washer
B3M1030I
TR0908