Subaru 2002 IMPREZA Service Manual page 1527

14) Remove the gear shift lever.
B: INSTALLATION
1) Install the joint to transmission and secure with
the spring pin.
2) Insert the gear shift lever from room side.
NOTE:
After inserting the rod and stay, temporarily put
them onto transmission mount.
3) Lift-up the vehicle.
4) Install the joint to shifter arm.
5) Insert the straight pin.
MT GEAR SHIFT LEVER
6) Mount the cushion rubber on the body.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
B3M1827
7) Connect the rod to the joint.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
B3M1827
8) Connect the stay to transmission bracket.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
B3M1826A
9) Install the heat shield cover. (If equipped)
CS-13
(A) Stay
(B) Cushion rubber
(A) Stay
(B) Rod
(A) Stay
(B) Transmission bracket
CONTROL SYSTEMS
B3M1825A
B3M1824A
B3M1823A