Subaru 2002 IMPREZA Service Manual page 2428

POWER ASSISTED SYSTEM (POWER STEERING)
24) Apply liquid packing to at least 1/3 of the entire
perimeter of adjusting screw thread.
Liquid packing:
THREE BOND 1141
(1) Apply liquid packing to at least 1/3 of entire
perimeter.
25) Tighten the adjusting screw.
Tightening torque:
First; 7.4 N·m (0.75 kgf-m, 5.4 ft-lb)
Second; Back off 25 ° ° ° °
26) Install the lock nut. While holding the adjusting
screw with a wrench, tighten lock nut using ST.
ST 926230000 SPANNER
Tightening torque (Lock nut):
39 N·m (4.0 kgf-m, 28.9 ft-lb)
NOTE:
• Hold the adjusting screw with a wrench to pre-
vent it from turning while tightening lock nut.
• Make adjustment so that the steering wheel can
be rotated fully from lock to lock without binding.
27) Check for the service limit as per article of "Ser-
vice limit".<Ref. to PS-68, INSPECTION, Steering
Gearbox [RHD MODEL].> Make replacement and
adjustment if necessary.
STEERING GEARBOX [RHD MODEL]
S4M0385A
PS-66
28) Install the boot to housing.
NOTE:
• Before installing the boot, be sure to apply
grease to the groove of tie-rod.
• Install the fitting portions of boots to following
portions in both sides of assembled steering gear-
box.
The groove on gearbox
The groove on the rod
• Make sure that the boot is installed without un-
usual inflation or deflation.
29) Using a screwdriver, tighten the screw until
ends "A" and "B" of band come into contact with
each other.
CAUTION:
Use a new band.
NOTE:
Always tighten the band from the underside of gear
box.
S4M0151A
S4M0152A