Subaru 2002 IMPREZA Service Manual page 2052

DRIVE SHAFT SYSTEM
4) Using the ST1 and ST2, press a new bearing
into place.
ST1 927400000 HOUSING STAND
ST2 927100000 BEARING PULLER
CAUTION:
• Always press the outer race when installing
bearing.
• Be careful not to remove the plastic lock from
inner race when installing bearing.
• Charge the bearing with new grease when
outer race is not removed.
Specified grease:
SHELL 6459N
5) Using pliers, install the snap ring in its groove.
CAUTION:
Make sure to install it firmly to groove.
6) Using the ST1 and ST2, press the outer oil seal
until it contacts the bottom of housing.
ST1 927410000 OIL SEAL INSTALLER
ST2 927400000 HOUSING STAND
FRONT AXLE
7) Using the ST1 and ST2, press the inner oil seal
until it contacts circlip.
ST1 927410000
ST2 927400000
8) Invert the ST and housing.
ST 927400000
9) Apply sufficient grease to the oil seal lip.
Specified grease:
SHELL 6459N
CAUTION:
• If specified grease is not available, remove
the bearing grease and apply Auto Rex A in-
G4M0232
stead.
• Do not mix different types of grease.
10) Install the disc cover to housing the three bolts.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
11) Attach the hub to ST1 securely.
12) Clean dust or foreign particles from the pol-
ished surface of hub.
13) Using the ST2, press the bearing into hub by
driving inner race.
ST1 927080000
ST2 927120000
G4M0226
G4M0233
DS-22
OIL SEAL INSTALLER
HOUSING STAND
G4M0234
HOUSING STAND
HUB STAND
HUB INSTALLER
G4M0235