Subaru 2002 IMPREZA Service Manual page 1523

3. Select Cable
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Prior to removal, set the lever to "N" position.
4) Lift-up the vehicle.
5) Remove the front and center exhaust pipe.
Non-turbo model with OBD
<Ref. to EX-7, REMOVAL, Front Exhaust Pipe.>
Non-turbo model without OBD
<Ref. to EX(w/oOBD)-9, REMOVAL, Front Exhaust
Pipe.>
Turbo model
<Ref. to EX(w/oOBD)-12, REMOVAL, Center Ex-
haust Pipe.>
6) Remove the heat shield cover. (If equipped)
7) Remove the snap pin from range select lever.
(A) Range select lever
(B) Snap pin
(C) Select cable
(D) Clamp
(E) Washer
8) Remove the plate assembly from transmission
case.
(A) Select cable
(B) Plate ASSY
(C) Clamp
SELECT CABLE
9) Disconnect the cable from select lever, and then
remove the cable bracket.
10) Remove the select cable from plate assembly.
B: INSTALLATION
1) Install the select cable to plate assembly.
Tightening torque:
32 N·m (3.3 kgf-m, 24 ft-lb)
2) Install the select cable to range select lever.
3) Install the plate assembly to transmission.
Tightening torque:
T: 24.5 N·m (2.5 kgf-m, 18.1 ft-lb)
TR0895
B3M1030E
CS-9
(A) Adjusting nuts
(B) Cable bracket
(A) Select cable
(B) Plate ASSY
CONTROL SYSTEMS
B3M1795A
B3M1030G