Subaru 2002 IMPREZA Service Manual page 2403

18) Install the gasket on valve assembly. Insert the
valve assembly into place while facing rack teeth
toward pinion.
CAUTION:
Be sure to use a new gasket.
NOTE:
Do not allow packing to be caught when installing
valve assembly.
19) Tighten the bolts alternately to secure valve as-
sembly.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
CAUTION:
Be sure to alternately tighten the bolts.
20) Apply grease to the sliding surface of sleeve
and spring seat, then insert the sleeve into pinion
housing. Fit the spring into sleeve screw, pack
grease inside of screw, then install the screw.
(1) Adjusting screw
(2) Spring
(3) Sleeve
STEERING GEARBOX [LHD MODEL]
S4M0155
B4M1129B
PS-41
POWER ASSISTED SYSTEM (POWER STEERING)
21) Install the lock washers, and then tighten the
right and left tie-rods into the rack ends.
On condition
L: Approx. 40 mm (1.57 in)
Tightening torque:
78 N·m (8.0 kgf-m, 57.9 ft-lb)
(1) Tie-rod
22) Bend the lock washer using a chisel.
CAUTION:
Be careful not to scratch the rack when bending
lock washer.
(1) Lock washer
S4M0150B
S4M0384A