Subaru 2002 IMPREZA Service Manual page 2416

POWER ASSISTED SYSTEM (POWER STEERING)
13) Remove the clamp bolts securing gearbox to
crossmember, and then remove the gearbox.
(1) Clamp
B: INSTALLATION
1) Insert the gearbox into crossmember, being
careful not to damage the gearbox boot.
2) Tighten the gearbox to crossmember bracket via
clamp with bolt to specified torque.
Tightening torque:
59 N·m (6.0 kgf-m, 43.4 ft-lb)
(1) Clamp
3) Connect the pipe D first from control valve, and
pipe C second.
Tightening torque:
T: 15 N·m (1.5 kgf-m, 10.8 ft-lb)
(1) Pipe C
(2) Pipe D
STEERING GEARBOX [RHD MODEL]
ST0010
ST0010
ST0026
PS-54
4) Install the universal joint. <Ref. to PS-27, IN-
STALLATION, Universal Joint.>
5) Connect the tie-rod end and knuckle arm, and
tighten with castle nut. Fit the cotter pin into nut,
and then bend the pin to lock.
Castle nut tightening torque:
Tighten to 27 N·m (2.75 kgf-m, 19.9 ft-lb), and
tighten further within 60 ° ° ° ° until cotter pin hole
is aligned with a slot in the nut.
CAUTION:
When connecting, do not hit the cap at bottom
of tie-rod end with hammer.
(1) Castle nut
(2) Tie-rod end
(3) Knuckle arm
6) Install the front stabilizer to vehicle.
7) Install the front exhaust pipe assembly.
8) Install the sub frame.
Tightening torque:
45 N·m (4.6 kgf-m, 33.3 ft-lb)
9) Install the under cover.
10) Align the center of roll connector. <Ref. to AB-
17, ADJUSTMENT, Roll Connector.>
CAUTION:
Ensure the front wheels are set in straight for-
ward direction.
11) Install the steering wheel. <Ref. to PS-26, IN-
STALLATION, Steering Wheel.>
12) Install the tires.
13) Tighten the wheel nuts to specified torque.
Tightening torque:
90 N·m (9.1 kgf-m, 65.8 ft-lb)
14) Connect the battery ground cable to battery.
15) Pour fluid into the oil tank, and bleed air.
<Ref. to PS-107, Power Steering Fluid.>
16) Check for fluid leaks.
17) Install the jack-up plate.
18) Lower the vehicle.
19) Check the fluid level in oil tank.
S4M0379A