Subaru 2002 IMPREZA Service Manual page 2049

9) Using a puller, remove the tie-rod ball joint from
knuckle arm.
10) On ABS equipped models, remove the ABS
sensor assembly and harness in advance.
11) Remove the transverse link ball joint from
housing.
12) After scribing an alignment mark on the camber
adjusting bolt head, remove the bolts which con-
nect housing and strut, and disconnect housing
from strut.
FRONT AXLE
B: INSTALLATION
1) Install the transverse link ball joint to housing.
Tightening torque:
49 N·m (5.0 kgf-m, 36 ft-lb)
2) While aligning the alignment mark on the cam-
ber adjusting bolt head, connect housing and strut.
CAUTION:
Use a new self-locking nut.
Tightening torque:
152 N·m (15.5 kgf-m, 112 ft-lb)
3) Install the ABS sensor on housing (only vehicle
B4M2215
equipped with ABS).
Tightening torque:
32 N·m (3.3 kgf-m, 23.9 ft-lb)
4) Install the disc rotor on hub.
5) Install the disc brake caliper on housing.
Tightening torque:
78 N·m (8 kgf-m, 57.9 ft-lb)
6) Install the front drive shaft. <Ref. to DS-33, IN-
STALLATION, Front Drive Shaft.>
7) Connect the stabilizer link.
8) Connect the tie-rod end ball joint and knuckle
arm with a castle nut, and then insert the cotter pin
B4M2209
into tie-rod end.
Tightening torque:
27.0 N·m (2.75 kgf-m, 19.9 ft-lb)
B4M2216
B4M1970
DS-19
DRIVE SHAFT SYSTEM
(A) Cotter pin
(B) Castle nut
(C) Tie-rod
B4M2214A