Subaru 2002 IMPREZA Service Manual page 1797

MAIN SHAFT ASSEMBLY FOR SINGLE-RANGE
3) Install the 4th needle bearing race onto trans-
mission main shaft using ST1, ST2 and a press.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
(A) 4th needle bearing race
4) Install the baulk ring, needle bearing, 4th drive
gear and 4th gear thrust washer to transmission
main shaft.
NOTE:
Align the baulk ring and gear & hub assembly with
key groove.
(A) Groove
(B) 4th gear side
5) Drive the ball bearing onto the rear section of
transmission main shaft using ST1, ST2 and a
press.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
ST1 899714110
ST2 499877000
B3M0543D
6) Using the ST1 and ST2, install the 5th gear
thrust washer and 5th needle bearing race onto the
rear section of transmission main shaft.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
NOTE:
Face the thrust washer in correct direction.
ST1 899714110
ST2 499877000
S3M0045A
7) Install the bearing onto synchro cone.
MT-73
MANUAL TRANSMISSION AND DIFFERENTIAL
REMOVER
RACE 4-5 INSTALLER
REMOVER
RACE 4-5 INSTALLER
(A) Face this surface to 5th gear side.
B3M0553F
B3M0091D