Subaru 2002 IMPREZA Service Manual page 1761

B: INSTALLATION
1) Install the rear cushion rubber to transmission
assembly.
Tightening torque:
35 N·m (3.57 kgf-m, 25.8 ft-lb)
2) Install the clutch release lever and bearing onto
transmission. (Turbo model) <Ref. to CL-26, IN-
STALLATION, Release Bearing and Lever.>
3) Install the transmission onto engine.
(1) Gradually raise the transmission with trans-
mission jack.
(2) Engage them at splines.
NOTE:
Be careful not to strike the main shaft against clutch
cover.
4) Install the transmission rear crossmember.
Tightening torque:
T1: 70 N·m (7.1 kgf-m, 51 ft-lb)
T2: 140 N·m (14.3 kgf-m, 103 ft-lb)
5) Take off the transmission jack.
6) Tighten the nuts which hold lower side of trans-
mission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
MANUAL TRANSMISSION ASSEMBLY
G2M0832
B2M2790
MT-37
MANUAL TRANSMISSION AND DIFFERENTIAL
7) Connect the engine and transmission.
(1) Install the starter.
<Ref. to SC-6, INSTALLATION, Starter.>
(2) Tighten the bolt which holds right upper side
of transmission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
8) Remove the ST.
9) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
T2
10) Lift-up the vehicle.
11) Install the front drive shaft into transmission.
B2M2791
G2M0313
T1
TR0086