Subaru 2002 IMPREZA Service Manual page 1569

16) Remove the transmission rear crossmember
bolts.
17) Lower the AT jack.
NOTE:
Do not separate the AT jack and transmission.
18) Remove the oil cooler inlet and outlet pipe.
NOTE:
When removing the outlet pipe, be careful not to
lose balls and springs used with retaining screws.
19) Remove the front and rear vehicle speed sen-
sor and torque converter turbine speed sensor.
• Front vehicle speed sensor and torque
converter turbine speed sensor
(A) Front vehicle speed sensor
(B) Torque converter turbine speed sensor
• Rear vehicle speed sensor
(A) Rear vehicle speed sensor
(B) Front vehicle speed sensor
20) Remove the oil pan.
FRONT VEHICLE SPEED SENSOR
TR0544
B3M1066B
B3M1056B
AT-33
AUTOMATIC TRANSMISSION
21) Disconnect the duty solenoids and ATF tem-
perature sensor connectors. Remove the connec-
tors from clip and disconnect the connectors.
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
(I) Transfer duty solenoid (Brown)
(J) Transmission ground
22) Remove the harness assembly.
B: INSTALLATION
1) Pass the harness assembly through the hole in
the transmission case.
B3M2263I
B3M1067