Subaru 2002 IMPREZA Service Manual page 1561

10.Transmission Mounting Sys-
tem
A: REMOVAL
1. PITCHING STOPPER
1) Disconnect the ground cable from battery.
2) Remove the air cleaner case. (Non-turbo model)
<Ref. to IN-6, REMOVAL, Air Cleaner Case.>
3) Remove the intercooler. (Turbo model)
<Ref. to IN(TURBO)-10, REMOVAL, Intercooler.>
4) Remove the pitching stopper.
2. CROSSMEMBER AND CUSHION RUB-
BER
1) Disconnect the ground cable from battery.
2) Jack-up the vehicle and support it with sturdy
racks.
3) Remove the front, center, rear exhaust pipes
and muffler. (Non-turbo model) <Ref. to EX(w/
oOBD)-9, REMOVAL, Front Exhaust Pipe.>, <Ref.
to EX(w/oOBD)-13, REMOVAL, Rear Exhaust
Pipe.> and <Ref. to EX(w/oOBD)-14, REMOVAL,
Muffler.> or <Ref. to EX-7, REMOVAL, Front Ex-
haust Pipe.>, <Ref. to EX-11, REMOVAL, Rear Ex-
haust Pipe.> and <Ref. to EX-12, REMOVAL,
Muffler.>
4) Remove the center, rear exhaust pipe and muf-
fler. (Turbo model)
<Ref. to EX(TURBO)-8, REMOVAL, Center Ex-
haust Pipe.>, <Ref. to EX(TURBO)-13, REMOVAL,
Rear Exhaust Pipe.> and <Ref. to EX(TURBO)-14,
REMOVAL, Muffler.>
5) Remove the heat shield cover. (If equipped)
6) Set the transmission jack under the transmis-
sion.
CAUTION:
Make sure that the support plates of transmis-
sion jack don't touch the oil pan.
TRANSMISSION MOUNTING SYSTEM
TR0072
AT-25
AUTOMATIC TRANSMISSION
7) Remove the transmission rear crossmember.
8) Remove the rear cushion rubber.
B: INSTALLATION
1. PITCHING STOPPER
1) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
T2
2) Install the air cleaner case. (Non-turbo model)
<Ref. to IN-6, INSTALLATION, Air Cleaner Case.>
3) Install the intercooler. (Turbo model).
<Ref. to IN(TURBO)-11, INSTALLATION, Inter-
cooler.>
S2M0221
T1
TR0086