MAIN SHAFT ASSEMBLY FOR SINGLE-RANGE
5) Drive the ball bearing onto the rear section of
transmission main shaft using ST1, ST2 and a
press.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
ST1 899714110
REMOVER
ST2 499877000
RACE 4-5 INSTALLER
6) Using the ST1 and ST2, install the 5th gear
thrust washer and 5th needle bearing race onto the
rear section of transmission main shaft.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
NOTE:
Face the thrust washer in correct direction.
ST1 899714110
REMOVER
ST2 499877000
RACE 4-5 INSTALLER
(A) Face this surface to 5th gear side.
7) Install the bearing onto synchro cone.
8) Install the baulk ring and synchro cone onto 5th-
Rev sleeve and hub assembly using ST and a
press.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
NOTE:
• Use a new ball bearing.
• After press fitting, make sure the synchro cone
rotates freely.
ST 499757002
B3M0553F
9) Install the synchro cone stopper and snap ring to
5th-Rev sleeve and hub assembly.
B3M0091D
MT-71
MANUAL TRANSMISSION AND DIFFERENTIAL
INSTALLER
(A) Baulk ring
(B) Synchro cone
(C) Ball bearing
(A) Synchro cone stopper
(B) Snap ring
B3M1370A
B3M0435B