Subaru 2002 IMPREZA Service Manual page 1585

B: INSTALLATION
1) Install the oil cooler outlet and inlet pipes.
NOTE:
Be sure to use a new aluminum washer.
Tightening torque:
T1: 44 N·m (4.5 kgf-m, 32.5 ft-lb)
T2: 25 N·m (2.5 kgf-m, 18.1 ft-lb)
2) Install the ATF cooler pipe to frame.
ATF COOLER PIPE AND HOSE
B3M2059A
B3M2054
AT-49
AUTOMATIC TRANSMISSION
3) Connect the ATF cooler hose to pipe transmis-
sion side.
NOTE:
• Install so that the hose is not folded over, exces-
sively bent, or twisted.
• Be careful to insert the hose to the specified po-
sition.
4) Connect the ATF cooler hose to the pipe of radi-
ator side.
NOTE:
• Install so that the hose is not folded over, exces-
sively bent, or twisted.
• Be careful to insert the hose to the specified po-
sition.
5) Install the under cover.
6) Install the battery and washer tank.
7) Fill ATF. <Ref. to AT-9, Automatic Transmission
Fluid.>
NOTE:
Make sure there are no ATF leaks in joints between
the transmission, radiator, pipes, and hoses.
B3M2191
B3M2052