Subaru 2002 IMPREZA Service Manual page 1764

MANUAL TRANSMISSION AND DIFFERENTIAL
4. Transmission Mounting Sys-
tem
A: REMOVAL
1. PITCHING STOPPER
1) Disconnect the ground cable from battery.
2) Remove the air intake duct and cleaner case.
3) Remove the air intake duct (Non-turbo model).
<Ref. to IN-7, REMOVAL, Air Intake Duct.>
4) Remove the air cleaner case (Non-turbo model).
<Ref. to IN-6, REMOVAL, Air Cleaner Case.>
5) Remove the intercooler (Turbo model). <Ref. to
IN(TURBO)-10, REMOVAL, Intercooler.>
6) Remove the pitching stopper.
2. CROSSMEMBER AND CUSHION RUB-
BER
1) Disconnect the ground cable from battery.
2) Jack-up the vehicle and support it with sturdy
racks.
3) Remove the front and center exhaust pipes.
(Non-turbo model)
Without OBD
<Ref. to EX(w/oOBD)-9, REMOVAL, Front Exhaust
Pipe.>
With OBD
<Ref. to EX-7, REMOVAL, Front Exhaust Pipe.>
4) Remove the center exhaust pipe. (Turbo model)
<Ref. to EX(TURBO)-8, REMOVAL, Center Ex-
haust Pipe.>
5) Remove the rear exhaust pipe and muffler.
6) Remove the heat shield cover. (If equipped)
7) Set the transmission jack under the transmission
body.
CAUTION:
Always support the transmission case with a
transmission jack.
TRANSMISSION MOUNTING SYSTEM
TR0072
MT-40
8) Remove the rear crossmember.
9) Remove the rear cushion rubber.
B: INSTALLATION
1. PITCHING STOPPER
1) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
2) Install the air intake duct and cleaner case.
(Non-turbo model)
<Ref. to IN-6, INSTALLATION, Air Cleaner Case.>
and <Ref. to IN-7, INSTALLATION, Air Intake
Duct.>
3) Install the intercooler. (Turbo model)
<Ref. to IN(TURBO)-11, INSTALLATION, Inter-
cooler.>
4) Connect the battery ground cable to battery.
G2M0831