Subaru 2002 IMPREZA Service Manual page 1857

2) Install the clutch cover on flywheel and tighten
the bolts to specified torque.
NOTE:
• Align matching marks.
• Note the front and rear of the clutch disc when in-
stalling.
• Tighten the clutch cover installing bolts gradual-
ly. Each bolt should be tightened to the specified
torque in a crisscross fashion.
Tightening torque:
15.7 N·m (1.6 kgf-m, 11.6 ft-lb)
3) Remove the ST.
ST 499747100 CLUTCH DISC GUIDE
2. EXCEPT 2.5 L MODEL
1) Insert the ST into clutch disc and install them on
the flywheel by inserting the ST end into pilot bear-
ing.
NOTE:
When installing the clutch disc, be careful to its di-
rection.
ST 499747100 CLUTCH DISC GUIDE
(A) Flywheel side
CLUTCH DISC AND COVER
2) Install the clutch cover on flywheel and tighten
the bolts to specified torque.
NOTE:
• When installing the clutch cover on flywheel, po-
sition the clutch cover so that there is a gap of 120°
or more between "0" marks on the flywheel and
clutch cover. ("0" marks indicate the directions of
residual unbalance.)
• Note the front and rear of the clutch disc when in-
stalling.
• Temporarily tighten the bolts by hand. Each bolt
should be tightened to the specified torque in a
crisscross fashion.
Tightening torque:
B2M3346A
3) Remove the ST.
ST 499747100
4) Install the transmission assembly. <Ref. to MT-
37, INSTALLATION, Manual Transmission Assem-
B2M4608A bly.>
CL-21
15.7 N·m (1.6 kgf-m, 11.6 ft-lb)
(A) "0" marks
CLUTCH DISC GUIDE
CLUTCH SYSTEM
B2M1011B