Subaru 2002 IMPREZA Service Manual page 1522

CONTROL SYSTEMS
12) Install the rear exhaust pipe and muffler.
Non-turbo model with OBD
<Ref. to EX-11, INSTALLATION, Rear Exhaust
Pipe.>, <Ref. to EX-12, INSTALLATION, Muffler.>
Non-turbo model without OBD
<Ref. to EX(w/oOBD)-13, INSTALLATION, Rear
Exhaust Pipe.>, <Ref. to EX(w/oOBD)-14, IN-
STALLATION, Muffler.>
Turbo model
<Ref. to EX(TURBO)-13, INSTALLATION, Rear
Exhaust Pipe.>, <Ref. to EX(TURBO)-14, INSTAL-
LATION, Muffler.>
C: DISASSEMBLY
1) Remove the grip.
2) Remove the indicator light, and then remove the
indicator cover.
NOTE:
Be careful not to break the indicator light during re-
moval.
(A) Grip
(B) Indicator cover
(C) Indicator light
3) Remove the blind.
4) Remove the clips, and then remove the guide
plate.
(A) Clips
(B) Guide plate
SELECT LEVER
5) Remove the cap, and then extract the spring pin.
6) Remove the select lever lower, and then take
away the select lever upper from plate.
B3M1511A
D: ASSEMBLY
1) Clean all parts before assembly.
2) Apply grease [NIGTIGHT LYW No. 2 or equiva-
lent] to each parts. <Ref. to CS-3, AT Select Le-
ver.>
3) Assembly is in the reverse order of disassembly.
4) After completion of fitting, transfer the select le-
ver to range "P" — "1", then check whether the in-
dicator and select lever agree, whether the pointer
and position mark agree and what the operating
force is.
E: INSPECTION
1) Inspect the removed parts by comparing with
new ones for deformation, damage and wear. Cor-
rect or replace if defective.
B3M2177A
2) Confirm the following parts for operating condi-
tion before assembly. Moving condition of the se-
lector lever upper, it should move smoothly.
CS-8
(A) Spring pin
(B) Arm COMPL
(A) Select lever lower
(B) Select lever upper
(C) Plate
B3M1797A
B3M1848A