Subaru 2002 IMPREZA Service Manual page 1560

AUTOMATIC TRANSMISSION
17) Install the ATF level gauge guide, and connect
the ATF cooler hoses to pipe.
18) Install the propeller shaft. <Ref. to DS-16, IN-
STALLATION, Propeller Shaft.>
19) Install the heat shield cover. (If equipped)
20) Install the rear exhaust pipe and muffler as-
sembly.
Non-turbo model
<Ref. to EX(w/oOBD)-13, INSTALLATION, Rear
Exhaust Pipe.> and <Ref. to EX(w/oOBD)-14, IN-
STALLATION, Muffler.> or <Ref. to EX-11, IN-
STALLATION, Rear Exhaust Pipe.> and <Ref. to
EX-12, INSTALLATION, Muffler.>
Turbo model
<Ref. to EX(TURBO)-13, INSTALLATION, Rear
Exhaust Pipe.>, <Ref. to EX(TURBO)-14, INSTAL-
LATION, Muffler.>
21) Install the front and center exhaust pipe. (Non-
turbo model) <Ref. to EX(w/oOBD)-10, INSTALLA-
TION, Front Exhaust Pipe.> or <Ref. to EX-8, IN-
STALLATION, Front Exhaust Pipe.>
22) Install the center exhaust pipe. (Turbo model)
<Ref. to EX(TURBO)-9, INSTALLATION, Center
Exhaust Pipe.>
23) Install the under cover.
24) Lower the vehicle.
25) Install the ATF level gauge.
26) Connect the following connectors.
(1) Transmission harness connectors
(2) Transmission ground cable
27) Connect the following cables.
(1) Cruise control cable (With cruise control ve-
hicles)
AUTOMATIC TRANSMISSION ASSEMBLY
B3M2191
S2M0214
28) Install the air cleaner case stay. (Non-turbo
model)
Tightening torque:
16 N·m (1.6 kgf-m, 11.6 ft-lb)
29) Install the air cleaner case and intake duct.
(Non-turbo model) <Ref. to IN-6, INSTALLATION,
Air Cleaner Case.>, <Ref. to IN-7, INSTALLATION,
Air Intake Duct.>
30) Install the intercooler. (Turbo model)
<Ref. to IN(TURBO)-11, INSTALLATION, Inter-
cooler.>
31) Connect the battery ground cable to battery.
32) Fill ATF up to the middle of the "COLD" side on
level gauge by using the gauge hole. <Ref. to AT-9,
Automatic Transmission Fluid.>
33) Take off the vehicle from lift arms.
34) Check the select lever operation.
<Ref. to AT-28, INSPECTION, Inhibitor Switch.>
35) Check the ATF level. <Ref. to AT-9, Automatic
Transmission Fluid.>
36) Check the vehicle on the road tester. <Ref. to
AT-12, Road Test.>
AT-24