Subaru 2002 IMPREZA Service Manual page 2328

Hide thumbs Also See for 2002 IMPREZA:

Table of Contents

B: INSTALLATION

1) Mount the brake booster in position.

2) Connect the operating rod to brake pedal with

clevis pin and snap pin.

(2) Clevis pin

(3) Snap pin

(4) Operating rod

3) Connect the vacuum hose to brake booster.

4) Mount the master cylinder onto brake booster.

5) Connect the brake pipes to master cylinder.

6) Connect the electric connector for brake fluid

level indicator.

BRAKE BOOSTER

7) Adjust the operating rod of brake booster.

If it is not within specified value, adjust it by adjust-

ing the brake booster operating rod.

8) Measure the clearance between threaded end of

stop light switch and stopper.

If it is not within specified value, adjust it by adjust-

ing the position of stop light switch.

Be careful not to rotate the stop light switch.

Stop light switch clearance: A

0.3 mm (0.012 in)

9) Apply grease to operating rod connecting pin to

prevent it from wearing.

10) Bleed air from the brake system.

Tightening torque (Air bleeder screw):

8 N·m (0.8 kgf-m, 5.8 ft-lb)

11) Conduct road tests to ensure brakes do not

144.6 mm (5.69 in)

173.2 mm (6.82 in)

Chapters

Table of Contents

2001 impreza