Subaru 2002 IMPREZA Service Manual page 1815

12) Install the washer using ST1, ST2 and press.
NOTE:
• Discard the old lock nuts, replace with new ones.
• Secure the lock nut in four places.
ST1 499277100 BUSH 1-2 INSTALLER
ST2 499277200 INSTALLER
(A) Washer
13) Install the thrust bearing and needle bearing.
Install the driven shaft assembly.
DRIVE PINION SHAFT ASSEMBLY
B3M0080E
B3M0082
MT-91
MANUAL TRANSMISSION AND DIFFERENTIAL
14) Install the drive pinion collar, needle bearing,
adjusting washer No. 2, thrust bearing, adjusting
washer No. 1 and differential bevel gear sleeve in
that order.
NOTE:
Be careful because the spacer must be installed in
proper direction.
(A) Driven shaft
(B) Drive shaft
(C) Drive pinion collar
(D) Needle bearing (25 × 30 × 20)
(E) Washer No. 2 (25 × 36 × 4)
(F) Thrust bearing (25 × 37.5 × 3)
(G) Washer No. 1 (25 × 36 × t)
(H) Differential bevel gear sleeve
B3M0083D