Subaru 2002 IMPREZA Service Manual page 1886

CLUTCH SYSTEM
12.Clutch Switch
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Disconnect the connector from clutch switch.
3) Remove the clutch switch.
B: INSTALLATION
1) Move the clevis pin of the push rod right and left
and hold where it moves smoothly, then measure
stroke of clutch pedal.
Specified clutch pedal full stroke:A
130 — 135 mm (5.12 — 5.31 in)
Tightening torque:
T: 8 N·m (0.8 kgf-m, 5.8 ft-lb)
2) If the clutch pedal stroke is out of specification,
adjust the stroke. <Ref. to CL-46, ADJUSTMENT,
Clutch Pedal.>
3) Connect clutch switch connector.
C: INSPECTION
1) If the clutch switch does not operate properly (or
if it does not stop at the specified position), replace
with a new one.
Specified position: L
+1.5 +0.059
2 / mm (0.079
0
CLUTCH SWITCH
B4M1190C
/ in)
0
G4M0327
2) Check the clutch switch continuity. If continuity is
not as specified, replace the switch.
(1) Disconnect the clutch switch connector.
(2) Measure the resistance between 1 and 2 of
switch terminal.
Terminals/Specified resistance
When clutch pedal depressed:
1 — 2/Less than 1 Ω Ω Ω Ω
Terminals/Specified resistance
When clutch pedal not depressed:
1 — 2/More than 1 M Ω Ω Ω Ω
Clutch switch (With cruise control)
CL-50
2 1
B2M4122