Subaru 2002 IMPREZA Service Manual page 1882

CLUTCH SYSTEM
5) Install the clutch pedal to pedal bracket.
Tightening torque:
T: 29 N·m (3.0 kgf-m, 21.7 ft-lb)
6) Install the assist rod, bushing and assist spring
to clutch pedal and pedal bracket.
7) Install the PHV cable to clutch pedal. (Vehicle
with hill holder).
E: INSPECTION
1. CLUTCH PEDAL
Move the clutch pedal pads in the lateral direction
with a force of approximately 10 N (1 kgf, 2 lb) to
ensure pedal deflection is in specified range.
CAUTION:
If excessive deflection is noted, replace the
bushings with new ones.
Deflection of clutch pedal:
Service limit
5.0 mm (0.197 in) or less
(A) Clutch pedal
(B) Brake pedal
CLUTCH PEDAL
F: ADJUSTMENT
1. CLUTCH PEDAL
• Except 1.6 L MODEL
1) Turn the lock nuts until clutch pedal full stroke
length is within specifications.
CAUTION:
Do not attempt to turn the clutch switch to ad-
just clutch pedal full stroke length.
NOTE:
If lock nuts cannot adjust the clutch pedal full stroke
length to specifications, turn the master cylinder
push rod to adjust it.
B4M1753B
Specified clutch pedal full stroke: A
130 — 135 mm (5.12 — 5.31 in)
Tightening torque (Clutch switch lock nut):
T: 8 N·m (0.8 kgf-m, 5.8 ft-lb)
2) Turn the master cylinder push rod so that clevis
pin moves to the left and then to the right. Clevis pin
must move without resistance while it is rattling.
Tightening torque (Push rod lock nut):
T: 10 N·m (1.0 kgf-m, 7 ft-lb)
B2M4119A
CL-46
(A) Clevis pin
(B) Snap pin
(C) Push rod
B4M1190C
B4M1189G