Subaru 2002 IMPREZA Service Manual page 2429

30) Fix the boot end with clip (small).
CAUTION:
After installing, check the boot end is posi-
tioned into groove on tie-rod.
(1) Clip
31) Install the tie-rod end plate.
Tightening torque:
13 N·m (1.3 kgf-m, 9.4 ft-lb)
32) If the tie-rod end was removed, screw in the
lock nut and tie-rod end to screwed portion of tie-
rod, and then tighten the lock nut temporarily in a
position as shown in the figure.
Installed tie-rod length: L
15 mm (0.59 in) (WAGON)
25 mm (0.98 in) (SEDAN)
NOTE:
Pay attention to the difference between right and
left tie-rod ends.
STEERING GEARBOX [RHD MODEL]
S4M0144B
ST0084
G4M0126
PS-67
POWER ASSISTED SYSTEM (POWER STEERING)
33) Install the tie-rod end plate.
Tightening torque:
13 N·m (1.3 kgf-m, 9.4 ft-lb)
34) Inspect the gearbox as follows:
"A" Holding the tie-rod end, repeat lock to lock two
or three times as quickly as possible.
"B" Holding the tie-rod end, turn it slowly at a radius
one or two times as large as possible.
After all, make sure that the boot is installed in
specified position without deflation.
35) Remove the gearbox from ST.
ST 926200000 STAND
G4M0127