Subaru 2002 IMPREZA Service Manual page 2067

11) Install the snap ring to shaft.
CAUTION:
Confirm that the snap ring is completely fitted
in the shaft groove.
12) Fill 100 to 110 g (3.53 to 3.88 oz) of specified
grease into the interior of SFJ outer race.
13) Apply a coat of specified grease to the free ring
and trunnion.
14) Align the alignment marks on free ring and trun-
nion, and then install the free ring.
CAUTION:
Be careful with the free ring position.
15) Align the alignment marks on shaft and outer
race, and then install the outer race.
16) Install the circlip in the groove on SFJ outer
race.
CAUTION:
Pull the shaft lightly and assure that the circlip
is completely fitted in the groove.
FRONT DRIVE SHAFT
17) Apply an even coat of the specified grease 30
to 40 g (1.06 to 1.41 oz) to the entire inner surface
of boot.
18) Install the SFJ boot taking care not to twist it.
CAUTION:
• The inside of the larger end of SFJ boot and
boot groove shall be cleaned so as to be free
from grease and other substances.
• When installing the SFJ boot, position the
outer race of SFJ at center of its travel.
19) Put a band through the clip and wind twice in
alignment with band groove of boot.
CAUTION:
Use a new band.
20) Pinch the end of band with pliers. Hold the clip
and tighten securely.
NOTE:
When tightening the boot, exercise care so that air
within the boot is appropriate.
21) Tighten the band by using ST.
ST 925091000
NOTE:
Tighten the band until it cannot be moved by hand.
B4M0777
22) Tap on the clip with punch provided at the end
of ST.
ST 925091000
CAUTION:
Tap to an extent that the boot underneath is not
damaged.
B4M0774
DS-37
DRIVE SHAFT SYSTEM
BAND TIGHTENING TOOL
G4M0289
BAND TIGHTENING TOOL
G4M0290