20) Install the front exhaust pipe and center ex-
haust pipe. (Non-turbo model)
Without OBD
<Ref. to EX(w/oOBD)-10, INSTALLATION, Front
Exhaust Pipe.>
With OBD
<Ref. to EX-8, INSTALLATION, Front Exhaust
Pipe.>
21) Install the center exhaust pipe. (Turbo model)
<Ref. to EX(TURBO)-9, INSTALLATION, Center
Exhaust Pipe.>
22) Install the under cover.
23) Install the operating cylinder. (2.0 L and 2.5 L
model)
Tightening torque:
37 N·m (3.8 kgf-m, 27.5 ft-lb)
• Non-turbo MODEL
• Turbo MODEL
24) Connect the return spring and clutch cable.
(1.6 L model)
MANUAL TRANSMISSION ASSEMBLY
TR0069
TR0070
TR0070
G2M0545
MT-39
MANUAL TRANSMISSION AND DIFFERENTIAL
25) Install the drive select cable on transmission.
(Dual-range model)
(A) Snap pin
(B) Clevis pin
(C) Drive select cable
26) Connect the following connectors:
(1) Transmission ground cable
Tightening torque:
13 N·m (1.3 kgf-m, 9.4 ft-lb)
(2) Vehicle speed sensor connector
(3) Neutral position switch connector
(4) Back-up light switch connector
(5) High-low switch connector (Dual-range
model)
27) Install the air cleaner case stay.
Tightening torque:
16 N·m (1.6 kgf-m, 11.6 ft-lb)
28) Install the air cleaner case and duct.
29) Connect the battery ground cable to battery.
30) Take off the vehicle from lift arms.
S3M0641A