Subaru 2002 IMPREZA Service Manual page 1532

CONTROL SYSTEMS
5. MT Drive Select Lever
A: REMOVAL
1) Apply parking brake and place chocks to hold
the wheels.
2) Disconnect the ground cable from battery.
3) Set the drive select lever to HI position.
4) Remove the knob.
5) Remove the console box. <Ref. to EI-40, Con-
sole Box.>
6) Remove the bolt installing drive select lever as-
sembly on body.
7) Remove the flange nut, clip and then disconnect
the cable from lever assembly.
(A) Flange nut
(B) Lever COMPL
(C) Clip
MT DRIVE SELECT LEVER
B: INSTALLATION
1) Install the drive select lever.
Tightening torque:
2) Set the drive select lever to HI position.
3) Be sure to insert the cable eye end bolt into lever
arm slit.
B3M0766
B3M1846A
4) Tighten the nut where cable end bolt comes to a
stop.
Tightening torque:
5) Install in the reverse order of removal.
CS-18
18 N·m (1.8 kgf-m, 13.0 ft-lb)
(A) HI position
(A) Cable eye end bolt
(B) Lever arm
18 N·m (1.8 kgf-m, 13.0 ft-lb)
B3M1516A
B3M1517A