AUTOMATIC TRANSMISSION
2) Connect the harness connectors.
Connect the connectors of same color, and secure
the connectors to valve body using clips.
Tightening torque (Transmission ground cable)
8 N·m (0.8 kgf-m, 5.8 ft-lb)
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
(I) Transfer duty solenoid (Brown)
(J) Transmission ground
3) Apply proper amount of liquid gasket to the en-
tire oil pan mating surface.
Fluid packing:
THREE BOND 1217B
FRONT VEHICLE SPEED SENSOR
B2M22631
B3M1040
AT-34
4) Apply liquid gasket fully to three holes other than
screw holes on transmission case.
Fluid packing:
THREE BOND 1217B
5) Install the oil pan.
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
6) Install the front and rear vehicle speed sensor,
and also the torque converter turbine speed sen-
sor, and then fasten the harness.
Tightening torque:
7 N·m (0.7 kgf-m, 5.1 ft-lb)
7) Install the oil cooler pipes.
NOTE:
Be sure to use a new aluminum washer.
Tightening torque:
T1: 44 N·m (4.5 kgf-m, 32.5 ft-lb)
T2: 25 N·m (2.5 kgf-m, 18.1 ft-lb)
8) Install the transmission rear crossmember bolts.
Tightening torque:
70 N·m (7.1 kgf-m, 51 ft-lb)
B3M2265
B3M2059A