2. CROSSMEMBER AND CUSHION RUB-
BER
1) Install the rear cushion rubber.
Tightening torque:
35 N·m (3.6 kgf-m, 26 ft-lb)
2) Install the rear crossmember.
Tightening torque:
T1: 70 N·m (7.1 kgf-m, 51 ft-lb)
T2: 140 N·m (14.3 kgf-m, 103 ft-lb)
3) Remove the transmission jack.
4) Install the heat shield cover. (If equipped)
5) Install the front and center exhaust pipes. (Non-
turbo model)
Without OBD
<Ref. to EX(w/oOBD)-10, INSTALLATION, Front
Exhaust Pipe.>
With OBD
<Ref. to EX-8, INSTALLATION, Front Exhaust
Pipe.>
6) Install the center exhaust pipe. (Turbo model)
<Ref. to EX(TURBO)-9, INSTALLATION, Center
Exhaust Pipe.>
7) Install the rear exhaust pipe and muffler.
TRANSMISSION MOUNTING SYSTEM
G2M0832
MT-41
MANUAL TRANSMISSION AND DIFFERENTIAL
C: INSPECTION
Repair or replace parts if the results of the inspec-
tion below are not satisfactory.
1. PITCHING STOPPER
Make sure that the pitching stopper is not bent or
damaged. Make sure that the rubber is not stiff,
cracked, or otherwise damaged.
2. CROSSMEMBER AND CUSHION RUB-
BER
Make sure that the crossmember is not bent or
damaged. Make sure that the cushion rubber is not
stiff, cracked, or otherwise damaged.