Subaru 2002 IMPREZA Service Manual page 2091

5. Rear ABS Sensor
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Lift-up the vehicle.
3) Remove the rear seat and disconnect the rear
ABS sensor connector.
4) Remove the rear sensor harness bracket from
the rear trailing link and bracket.
5) Remove the rear ABS sensor from back plate.
(1) Rear ABS sensor
6) Remove the rear tone wheel while removing the
hub from housing and hub assembly.<Ref. to DS-
24, REMOVAL, Rear Axle.>
CAUTION:
• Be careful not to damage the pole piece locat-
ed at tip of the sensor and teeth faces during re-
moval.
• Do not pull the sensor harness during remov-
al.
REAR ABS SENSOR
B: INSTALLATION
1) Install the rear tone wheel on hub, then rear
housing on hub.<Ref. to DS-30, ASSEMBLY, Rear
Axle.>
2) Temporarily install the rear ABS sensor on back
plate.
CAUTION:
Be careful not to strike the ABS sensor's pole
piece and tone wheel's teeth against adjacent
metal parts during installation.
BR0095
3) Install the rear drive shaft to rear housing and
rear differential spindle.<Ref. to DS-27, INSTALLA-
TION, Rear Axle.>
4) Install the rear sensor harness on rear trailing
link.
Tightening torque:
32 N·m (3.3 kgf-m, 24 ft-lb)
ABS-17
(1) Rear ABS sensor
(1) Rear sensor harness
(2) Trailing link
ABS
BR0095
BR0096