Subaru 2002 IMPREZA Service Manual page 2071

Hide thumbs Also See for 2002 IMPREZA:

Table of Contents

Use specified grease.

Molylex No. 2 (Part No. 723223010)

VU-3A702 (Yellow) (Part No. 23223GA050)

1) Install the BJ boot in specified position, and fill it

with 60 to 70 g (2.12 to 2.47 oz) of specified grease.

2) Place the DOJ boot at the center of shaft.

Be sure to wrap the shaft splines with vinyl tape

to prevent boot from scratches.

3) Insert the DOJ cage onto shaft.

Insert the cage with cut-out portion facing the shaft

end, since the cage has an orientation.

(B) Cut-out portion

4) Install the DOJ inner race on shaft and fit snap

ring with pliers.

Confirm that the snap ring is completely fitted in

shaft groove.

REAR DRIVE SHAFT

5) Install the cage, which was previously fitted, to

inner race fixed upon shaft.

Fit the cage with protruded part aligned with the

track on inner race, and then turn by a half pitch.

6) Fill 80 to 90 g (2.82 to 3.17 oz) of specified

grease into the interior of DOJ outer race.

7) Apply a coat of specified grease to the cage

pocket and six balls.

8) Insert six balls into the cage pocket.

9) Align the outer race track and ball positions and

place in the part where shaft, inner race, cage and

balls are previously installed, and then fit outer

DRIVE SHAFT SYSTEM

(A) Inner race

(A) Outer race

Chapters

Table of Contents

2001 impreza