Subaru 2002 IMPREZA Service Manual page 2117

2. READ CURRENT DATA
1) On the «Main Menu» display screen, select the {Each System Check} and press «YES» key.
2) On the «System Selection Menu» display screen, select the {Brake Control System} and press «YES»
key.
3) Press the «YES» key after displayed the information of ABS type.
4) On the «Brake Control Diagnosis» display screen, select the {Current Data Display & Save} and press
«YES» key.
5) On the «Data Display Menu» display screen, select the {Data Display} and press «YES» key.
6) Using the scroll key, move the display screen up or down until desired data is shown.
• A list of the support data is shown in the following table.
Display screen
FR Wheel Speed
FL Wheel Speed
RR Wheel Speed
RL Wheel Speed
Stop Light Switch
Stop Light Switch
G sensor output Signal
Valve Relay Signal
Motor Relay Signal
ABS Signal to TCM
ABS Warning Lamp
Motor Relay Monitor
Valve Relay Monitor
CCM Signal
NOTE:
For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
3. CLEAR MEMORY MODE
1) On the «Main Menu» display screen, select the {2. Each System Check} and press «YES» key.
2) On the «System Select Menu» display screen, select the {Brake System} and press «YES» key.
3) Press the «YES» key after displayed the information of engine type.
4) On the «Brake Control Diagnosis» display screen, select the {Clear Memory} and press «YES» key.
5) When the "Done" and "turn ignition switch to OFF" are shown on display screen, turn the Subaru Select
Monitor and ignition switch to OFF.
NOTE:
For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
SUBARU SELECT MONITOR
Contents to be monitored
Wheel speed detected by Front Right ABS sensor is displayed
Wheel speed detected by Front Left ABS sensor is displayed
Wheel speed detected by Rear Right ABS sensor is displayed
Wheel speed detected by Rear Left ABS sensor is displayed
Stop light switch signal
Stop light switch monitor voltage is displayed.
Refers to vehicle acceleration detecting by analog G sensor. It
appears on the select monitor display in volts.
Valve Relay Signal
Motor Relay Signal
ABS operation signal from ABS control module to TCM
ON operation of ABS warning light is displayed.
Operating condition of motor relay is displayed.
Operating condition of the valve relay is displayed.
ABS operation signal from ABS control module to TCM
ABS-19
ABS (DIAGNOSTICS)
Unit of measure
km/h or MPH
km/h or MPH
km/h or MPH
km/h or MPH
ON or OFF
V
V
ON or OFF
ON or OFF
ON or OFF
ON or OFF
High or Low
ON or OFF
ON or OFF