SHIFT SOLENOIDS, DUTY SOLENOIDS AND ATF TEMPERATURE SENSOR
8) Remove the rear exhaust pipe and muffler.
Non-turbo model
<Ref. to EX(w/oOBD)-13, REMOVAL, Rear Ex-
haust Pipe.> and <Ref. to EX(w/oOBD)-14, RE-
MOVAL, Muffler.> or <Ref. to EX-11, REMOVAL,
Rear Exhaust Pipe.> and <Ref. to EX-12, REMOV-
AL, Muffler.>
Turbo model
<Ref. to EX(TURBO)-13, REMOVAL, Rear Ex-
haust Pipe.> and <Ref. to EX(TURBO)-14, RE-
MOVAL, Muffler.>
9) Raise the vehicle and drain the ATF.
(A) Oil pan
(B) Drain plug
(C) Deferential oil drain plug
10) Remove the heat shield cover.
11) Remove the propeller shaft. <Ref. to DS-15,
REMOVAL, Propeller Shaft.>
12) Remove the transmission rear crossmember.
(1) Support the transmission using a transmis-
sion jack and raise slightly.
(2) Remove the bolts and nuts as shown in the
figure.
13) Remove the rear vehicle speed sensor.
14) Remove the select cable nut.
B3M1036B
15) Move the gear select cable so that extension
bolts can be removed.
16) Remove the bolts.
17) Remove the extension case.
NOTE:
Use a container to catch oil flowing from extension.
18) Disconnect the transfer duty solenoid connec-
tor.
S2M0221
AT-41
AUTOMATIC TRANSMISSION
B3M1043
B3M0308
B3M1044