Subaru 2002 IMPREZA Service Manual page 2058

DRIVE SHAFT SYSTEM
6) Connect the parking brake cable to parking
brake.
7) Install the disc rotor on rear housing assembly.
8) Install the disc brake caliper on back plate.
Tightening torque:
52 N·m (5.3 kgf-m, 38.3 ft-lb)
9) Install the rear ABS sensor and brake cable
bracket (only vehicle equipped with ABS).
(1) ABS sensor
10) Bleed the air from brake system. <Ref. to BR-
55, REPLACEMENT, Brake Fluid.>
11) Adjust the parking brake lever stroke by turning
adjuster.
12) Move the brake lever back to apply brakes.
While depressing the brake pedal, tighten axle nut
using a socket wrench. Lock the axle nut after tight-
ening.
Tightening torque:
186 N·m (19 kgf-m, 137 ft-lb)
CAUTION:
• Use a new axle nut.
• Always tighten the axle nut before installing
wheel on the vehicle. If the wheel is installed
and comes in contact with ground when axle
nut is loose, wheel bearings may be damaged.
• Be sure to tighten the axle nut to specified
torque. Do not overtighten it as this may dam-
age the wheel bearing.
REAR AXLE
13) Install the wheel, and then tighten the wheel
nuts to specified torque.
Tightening torque:
88 N·m (9.0 kgf-m, 65 ft-lb)
2. DRUM BRAKE
1) Connect the rear housing assembly and strut as-
sembly.
CAUTION:
Use a new self-locking nut.
Tightening torque:
196 N·m (20 kgf-m, 145 ft-lb)
2) Fit the BJ (bell joint) to rear housing splines.
CAUTION:
Be careful not to damage the inner oil seal lip.
G4M0240
3) Connect the rear housing assembly to lateral link
assembly.
CAUTION:
Use a new self-locking nut.
Tightening torque:
137 N·m (14 kgf-m, 101 ft-lb)
H4M1139B
4) Connect the rear housing assembly to trailing
link assembly.
CAUTION:
Use a new self-locking nut.
Tightening torque:
113 N·m (11.5 kgf-m, 83 ft-lb)
DS-28
S4M0110
S4M0109