Subaru 2002 IMPREZA Service Manual page 1802

MANUAL TRANSMISSION AND DIFFERENTIAL
8) Remove rest of the parts.
(A) Sleeve and hub ASSY
(B) High-low baulk ring
(C) Friction damper
(D) Low input gear
(E) Needle bearing
(F) Input low gear spacer
(G) Ball
D: ASSEMBLY
1) Assemble when each sleeve and hub assembly
are disassembled.
NOTE:
Position the open ends of spring 120° apart.
(A) High-low coupling sleeve
(B) Shifting insert
(C) High-low synchronizer spring
(D) High-low synchronizer hub
(E) Sleeve
(F) Insert key
(G) 3rd-4th synchronizer hub
(H) Sleeve
(I) Insert key
(J) 5th-Rev synchronizer hub
MAIN SHAFT ASSEMBLY FOR DUAL-RANGE
S3M0169A
S3M0444A
2) Install the 3rd drive gear, baulk ring, sleeve and
hub assembly for 3rd-4th needle bearing on trans-
mission main shaft.
NOTE:
Align the groove in baulk ring with shifting insert.
3) Install the 4th needle bearing race onto trans-
mission main shaft using ST1, ST2 and a press.
ST1 899714110
ST2 499877000
(A) 4th needle bearing race
4) Install the baulk ring, needle bearing, 4th drive
gear and 4th gear thrust washer to transmission
main shaft.
NOTE:
Face the thrust washer in correct direction.
(A) Groove
(B) 4th gear side
MT-78
REMOVER
RACE 4-5 INSTALLER
B3M0543D
S3M0045A