Subaru 2002 IMPREZA Service Manual page 2324

BRAKE
D: ASSEMBLY
1) Clean all parts in brake fluid. Check and replace
the faulty parts.
• Cup and boot for damage or fatigue
• Cylinder, piston and spring or damage or rust for-
mation
2) Assemble in the reverse order of disassembly.
(1) When installing the cup, use ST, apply
brake fluid to the frictional surface for smooth in-
stallation and pay attention to cup direction.
(2) STs are available in different sizes.
CAUTION:
• When replacing the repair kit, make sure that
the sizes of cylinder and cup are same as those
which were replaced.
• Use only the tool of correct size.
ST: ADAPTER
Applicable size
17.5 mm (11/16 in)
CAUTION:
While assembling, be careful to prevent any
metal chip, dust or dirt from entering the wheel
cylinder.
(1) Cup
(2) Piston
REAR DRUM BRAKE ASSEMBLY
Part No.
925460000
S4M0455A
BR-46
3) Apply rubber grease to the boot inside as shown
in the figure.
CAUTION:
Never use brake grease.
Grease:
NIGLUBE RX-2 (Part No. 003606000)
E: INSPECTION
1) If the deformation or wear of back plate, shoe,
etc. are notable, replace them.
S4M0456B