Subaru 2002 IMPREZA Service Manual page 1558

AUTOMATIC TRANSMISSION
3) Install the transmission onto engine.
(1) Gradually raise the transmission with trans-
mission jack.
(2) Engage them at splines.
4) Install the transmission rear crossmember.
Tightening torque:
T1: 35 N·m (3.6 kgf-m, 26 ft-lb)
T2: 70 N·m (7.1 kgf-m, 51 ft-lb)
5) Take off the transmission jack.
6) Tighten the nuts and bolts which hold lower side
of transmission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
7) Lower the vehicle.
AUTOMATIC TRANSMISSION ASSEMBLY
B2M0035
S2M0021A
B3M2047
8) Connect the engine and transmission.
(1) Remove the ST from torque converter clutch
case.
NOTE:
Be careful not to drop the ST into torque converter
clutch case when removing the ST.
ST 498277200
(2) Install the starter.
<Ref. to SC-6, INSTALLATION, Starter.>
(3) Tighten the bolt which holds right upper side
of transmission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
9) Install the torque converter clutch to drive plate.
(1) Tighten the bolts which hold torque convert-
er clutch to drive plate.
(2) Tighten the other bolts while rotating the en-
gine by using ST.
NOTE:
Be careful not to drop bolts into torque converter
clutch housing.
Except 2.5 L model
ST 499977300
2.5 L model
ST 499977100
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
(3) Clog the plug onto service hole.
AT-22
STOPPER SET
B3M2044
CRANK PULLEY WRENCH
CRANK PULLEY WRENCH
S2M0207