Subaru 2002 IMPREZA Service Manual page 1578

SHIFT SOLENOIDS, DUTY SOLENOIDS AND ATF TEMPERATURE SENSOR
AUTOMATIC TRANSMISSION
19) Remove the transfer duty solenoid and transfer
valve body.
(A) Transfer valve body
(B) Transfer duty solenoid connector
(C) Transfer duty solenoid
B: INSTALLATION
1) Install the solenoids and ATF temperature sen-
sor.
Tightening torque:
T: 8 N·m (0.8 kgf-m, 5.8 ft-lb)
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
2) Connect the harness connectors.
Connect the connectors of same color, and secure
the connectors to valve body using clips.
B3M1045F
3) Apply proper amount of liquid gasket to the en-
tire oil pan mating surface.
Fluid packing:
THREE BOND 1217B
B3M1039B
4) Apply liquid gasket fully to three holes other than
screw holes on transmission case.
Fluid packing:
THREE BOND 1217B
AT-42
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
(I) Transfer duty solenoid (Brown)
B2M2263J
B3M1040
B3M2265