Subaru 2002 IMPREZA Service Manual page 1866

CLUTCH SYSTEM
B: INSTALLATION
1) Install in the reverse order of removal.
NOTE:
Before installing the operating cylinder, apply
grease (SUNLIGHT 2: P/N 003602010) to contact
point of the release lever and operating cylinder.
Tightening torque:
T1: 18 N·m (1.8 kgf-m, 13.0 ft-lb)
T2: 37 N·m (3.8 kgf-m, 27.5 ft-lb)
• Non-turbo MODEL
• Turbo MODEL
NOTE:
• Be sure to install the clutch hose with the mark
side facing upward.
• Be careful not to twist the clutch hose during in-
stallation.
(A) Marking
(B) Clutch hose
(C) Operating cylinder
OPERATING CYLINDER
2) After bleeding air from the operating cylinder,
ensure that clutch operates properly.
<Ref. to CL-38, Clutch Fluid Air Bleeding.>
C: INSPECTION
1) Check the operating cylinder for damage. If op-
erating cylinder is damaged, replace it.
2) Check the operating cylinder for fluid leakage or
damage on boot. If any leakage or damage is
found, replace the operating cylinder.
B2M1179C
G2M0978
H2M2666B
CL-30