Subaru 2002 IMPREZA Service Manual page 1875

5) Tighten the air bleeder. (RHD turbo model)
Tightening torque:
T: 8 N·m (0.8 kgf-m, 5.8 ft-lb)
T
6) Remove the operationg cylinder.
NOTE:
Do not remove the clutch hose.
7) Fix the piston with clamp to avoid the piston from
jumping out.
8) Fit one end of a vinyl tube into the air bleeder of
operating cylinder and put the other end into a
brake fluid container.
CLUTCH FLUID AIR BLEEDING
TR0910
TR0070
TR0892
CL-39
9) Slowly depress the clutch pedal and keep it de-
pressed. Then open the air bleeder to discharge air
together with the fluid.
Release the air bleeder for 1 or 2 seconds. Next,
with the bleeder closed, slowly release the clutch
pedal.
NOTE:
Set the air breather screw part higher than tip of op-
erating cylinder when performing this procedure.
(A)
(A) Operating cylinder
(B) Vinyl tube
10) Repeat these steps until there are no more air
bubbles in the vinyl tube.
CAUTION:
Cover the bleeder with waste cloth when loos-
ening it, to prevent brake fluid from being
splashed over surrounding parts.
CLUTCH SYSTEM
(B)
TR0893