Subaru 2002 IMPREZA Service Manual page 1562

AUTOMATIC TRANSMISSION
2. CROSSMEMBER AND CUSHION RUB-
BER
1) Install the rear cushion rubber.
Tightening torque:
39 N·m (4.0 kgf-m, 29 ft-lb)
2) Install the crossmember.
Tightening torque:
T1: 35 N·m (3.6 kgf-m, 26 ft-lb)
T2: 70 N·m (7.1 kgf-m, 51 ft-lb)
3) Remove the transmission jack.
4) Install the heat shield cover. (If equipped)
5) Install the front, center, rear exhaust pipes and
the muffler. (Non-turbo model) <Ref. to EX(w/
oOBD)-10, INSTALLATION, Front Exhaust Pipe.>,
<Ref. to EX(w/oOBD)-13, INSTALLATION, Rear
Exhaust Pipe.> and <Ref. to EX(w/oOBD)-14, IN-
STALLATION, Muffler.> or <Ref. to EX-8, INSTAL-
LATION, Front Exhaust Pipe.>, <Ref. to EX-11,
INSTALLATION, Rear Exhaust Pipe.> and <Ref. to
EX-12, INSTALLATION, Muffler.>
6) Install the center, rear exhaust pipe and muffler.
(Turbo model)
<Ref. to EX(TURBO)-9, INSTALLATION, Center
Exhaust Pipe.>, <Ref. to EX(TURBO)-13, INSTAL-
LATION, Rear Exhaust Pipe.> and <Ref. to
EX(TURBO)-14, INSTALLATION, Muffler.>
TRANSMISSION MOUNTING SYSTEM
S2M0221A
AT-26
C: INSPECTION
Repair or replace parts if the results of the inspec-
tion below are not satisfactory.
1. PITCHING STOPPER
Make sure that the pitching stopper is not bent or
damaged. Make sure that the rubber is not stiff,
cracked, or otherwise damaged.
2. CROSSMEMBER AND CUSHION RUB-
BER
Make sure that the crossmember is not bent or
damaged. Make sure that the cushion rubber is not
stiff, cracked, or otherwise damaged.