Subaru 2002 IMPREZA Service Manual page 2061

3) Clean the housing interior completely. Using the
ST1 and ST2, press the bearing into housing.
ST1 927430000 HOUSING STAND
ST2 927440000 BEARING REMOVER
CAUTION:
• Always press the outer race when installing
bearing.
• Be careful not to remove the plastic lock from
inner race when installing bearing.
• Charge bearing with new grease when outer
race is not removed.
4) Using pliers, install the snap ring.
CAUTION:
Ensure the snap ring fits in groove properly.
(1) Pliers
5) Using the ST1 and ST2, press the outer oil seal
unit it comes in contact with snap ring.
ST1 927430000 HOUSING STAND
ST2 927460000 OIL SEAL INSTALLER
6) Invert both ST1 and housing.
REAR AXLE
7) Using the ST2, press the inner oil seal into hous-
ing until it touches bottom.
ST1 927430000
ST2 927460000
8) Using the ST1 and ST2, press the sub seal into
place.
ST1 927430000
ST2 927460000
S4M0266A
9) Apply sufficient grease to oil seal lip.
Specified grease:
SHELL 6459N
CAUTION:
• If specified grease is not available, remove
S4M0371A
the bearing grease and apply Auto Rex A in-
stead.
• Do not mix different types of grease.
10) Install the back plate to rear housing.
Tightening torque:
52 N·m (5.3 kgf-m, 38.3 ft-lb)
S4M0267A
DS-31
DRIVE SHAFT SYSTEM
HOUSING STAND
OIL SEAL INSTALLER
S4M0268A
HOUSING STAND
OIL SEAL INSTALLER
S4M0269A