CONTROL SYSTEMS
4) Install the snap pin to range select lever.
(A) Range select lever
(B) Snap pin
(C) Select cable
(D) Clamp
(E) Washer
5) Move the select lever to "N" position, then adjust
the select cable position. <Ref. to CS-10, ADJUST-
MENT, Select Cable.>
6) Install the heat shield cover. (If equipped)
7) Install the front and center exhaust pipe.
Non-turbo model with OBD
<Ref. to EX-8, INSTALLATION, Front Exhaust
Pipe.>
Non-turbo model without OBD
<Ref. to EX(w/oOBD)-10, INSTALLATION, Front
Exhaust Pipe.>
Turbo model
<Ref. to EX(TURBO)-9, INSTALLATION, Center
Exhaust Pipe.>
C: INSPECTION
Check the removed cable and replace if damaged,
rusty, or malfunctioning.
1) Check for smooth operation of the cable.
2) Check the inner cable for damage and rust.
3) Check the outer cable for damage, bends, and
cracks.
4) Check the boot for damage, cracks, and deterio-
ration.
5) Move the select lever from "P" position to "1" po-
sition. You should be able to feel the detentes in
each position. If the detentes cannot be felt or the
position pointer is improperly aligned, adjust the ca-
ble.
SELECT CABLE
D: ADJUSTMENT
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Set the lever to "N" position.
4) Lift-up the vehicle.
5) Remove the rear exhaust pipe and muffler.
6) Remove the heat shield cover. (If equipped)
7) Loosen the adjusting nut on each side.
TR0895
8) Turn the adjusting nut B until it lightly touches
the connector.
CS-10
(A) Adjusting nut A
(B) Adjusting nut B
(A) Front side
(B) Select lever
(C) Connector
(D) Adjusting nut B
(E) Contact point
(F) Adjusting nut A
B3M1792A
B3M1793A